Plumber | Charlotte NC | How To Replace a Toilet

Plumber | Charlotte NC | How To Replace a Toilet

Replacing a toilet is not a minor task. If you are set to do it yourself, be sure to plan. You will need a set of indispensable tools and materials that are not commonly found in most homes. For the best results, our primary recommendation is to call on certificate plumber in Charlotte NC that can deliver the most efficient outcomes regarding time and money. But, if you feel that you can manage the challenge, below we list the main considerations you need to keep in mind.

BASIC PREPARATIONS

Before you begin any work, corroborate that the area is dry and clean. As you can expect, it will be some water spill later on but is easier and safer to attend to it while is happening rather than working in a growing pool. Moreover, is essential that you are positive to have all the necessary tools for the job, those are:

  • Adjustable wrenches of different sizes
  • Screwdrivers
  • Pipe Saws
  • Spatula
  • Cutter
  • Measuring tape
  • A set of towels

Likewise, verify that you have all the materials that you will need: Pipes, steel hose, plumbing putty, sealant, Teflon and, of course, your new toilet. Next, shut down completely your home´s water valve and locate the ventilation pipes, so the liquid and solid waste can freely be discharged from the toilet. Any toilet should be connected to a ventilation tube joined to the main discharge pipe.

REMOVING YOUR OLD TOILET

  • Disconnect the supply pipe using the adjustable wrench.
  • Remove all the internal components of your old toilet.
  • Take off all of the fixing screws.
  • Carefully detach your old toilet and cover the waste gap to prevent any contamination.
  • Using the spatula, clean off all the old plumbing putty.
  • Thoroughly clean the area where the new toilet will be installed.

INSTALLING THE NEW TOILET

  • Remove the cap covering the waste aperture.
  • Set the base in line with the anchor holes and fix it using the corresponding screws. Be careful not to tighten the screws too tight, or you may break the base of the toilet. Furthermore, try not to move the base excessively, so the seal remains intact.
  • Seal the base of the toilet with plumbing putty and let it dry.
  • Place the tank over the base of the toilet. Tight the screws in its position and secure them with the packing rings.
  • Install the filling valves following the manufacturer’s instructions.
  • Proceed to position the toilet seat in its place and secure it using its plugs.
  • Reconnect the supply pipe.

TESTING OUT THE WORK

Open the water valve and flush the new toilet a couple of times to check that everything was correctly installed. Pay particular attention to any possible leak.
Check that the toilet tank fills adequately between 30 and 60 seconds. Also, inspect that the floating device is functioning properly and that the water level in the tank is where it should be. If you notice that something is not working correctly, ask for the advice and guidance of an expert plumber in Charlotte NC.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s